Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR DISC
  1. Align the matchmarks of the disc and axle hub and install the disc.



2. ADJUST PARKING BRAKE SHOE CLEARANCE


D028131E01
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.

  1. Contract the shoe adjuster until the disc rotates smoothly.

    Standard:
    Return 8 notches

  1. Install the hole plug.



3. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


C133098
  1. Install the disc brake caliper with the 2 bolts and 2 washers.

    Torque:
    105 N*m{ 1,071 kgf*cm , 78 ft.*lbf }



4. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }



5. BED IN PARKING BRAKE SHOES TO DISCS
  1. Drive the vehicle at about 50 km/h (31 mph) on a safe, level and dry road.

  1. Depress the parking brake pedal with 150 N (15 kgf, 33.7 lbf) of force.

  1. Drive the vehicle for about 400 m (0.25 mile) in this condition.

  1. Repeat this procedure 3 times.

    NOTICE:
    Set a 5-minute interval between each procedure to prevent the brake assembly from overheating.



6. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)



7. ADJUST PARKING BRAKE LEVER TRAVEL


G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.