Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.



2. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.



3. REMOVE PARKING BRAKE SHOE


D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.



4. REMOVE PARKING BRAKE SHOE LEVER


D028129
  1. Using a screwdriver, remove the C-washer.

  1. Remove the shim and parking brake shoe lever from the No. 1 shoe.