Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL PARKING BRAKE SHOE LEVER


R000343E01
  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    Less than 0.25 mm (0.0098 in.)

    If the clearance is not within the specifications, replace the shim with one of the correct size.
    Part No.
    Shim Thickness
    90564-09184
    0.3 mm (0.012 in.)
    90564-09002
    0.4 mm (0.016 in.)
    90564-09003
    0.5 mm (0.020 in.)
    90564-09185
    0.6 mm (0.024 in.)
    90564-09186
    0.9 mm (0.035 in.)

  1. Using pliers, install the parking brake shoe lever and the shim with a new C-washer.



2. APPLY HIGH TEMPERATURE GREASE
  1. Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.



3. INSTALL PARKING BRAKE SHOE


F041705E03
  1. Apply high temperature grease to the adjusting bolt and piece.

  1. Using needle-nose pliers, connect the parking brake cable to the parking brake shoe lever.



    D028128
  1. Install the No. 1 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.

  1. Install the return tension spring and shoe adjusting screw set.

  1. Install the No. 2 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.



4. INSTALL PARKING BRAKE SHOE STRUT
  1. Attach the compression spring and parking brake shoe strut to the No. 2 and No. 1 shoes.



5. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING


D028127
  1. Using needle-nose pliers, install the 2 return tension springs.

    HINT:
    First install the front side spring then install the rear side spring.



6. CHECK PARKING BRAKE INSTALLATION


  1. Check that each part is installed properly.


    D028130E01

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining or the disc.