Home › BRAKE › PARKING BRAKE › PARKING BRAKE SWITCH

PARKING BRAKE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



6. REMOVE PARKING BRAKE SWITCH
  1. Disconnect the parking brake switch connector.



    C133100
  1. Remove the screw and parking brake switch.