Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    U0073    Control Module Communication Bus OFF

DTC    U0100    Lost Communication with ECM / PCM

DTC    U0123    Lost Communication with Yaw Rate Sensor Module

DTC    U0124    Lost Communication with Lateral Acceleration Sensor Module

DTC    U0126    Lost Communication with Steering Angle Sensor Module

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0073
When either of following conditions (1 or 2) detected:
  1. After data output from skid control ECU completed, output continues for 5 seconds or more.
  2. Bus off condition occurs once or more per 0.1 seconds 10 times in succession.
CAN communication system
U100
When IG1 terminal voltage 10 V or more and vehicle speed 9 mph (15 km/h) or more, either of following conditions (1 or 2) occurs 10 times in succession:
  1. Data cannot be sent to ECM once or more within 5 seconds.
  2. Data from ECM cannot be received once or more within 5 seconds.
CAN communication system
U0123
When IG1 terminal voltage 10 V or more, either of following conditions (1 or 2) detected:
  1. Data from yaw rate sensor cannot be received for 1 second or more.
  2. Data from yaw rate sensor cannot be received once or more within 5 seconds.
CAN communication system
U0124
When IG1 terminal voltage 9.5 V or more, either of following conditions (1 or 2) detected:
  1. Data from acceleration sensor cannot be received for 1 second or more.
  2. Data from acceleration sensor cannot be received once or more within 5 seconds.
CAN communication system
U0126
When IG1 terminal voltage 10 V or more, either of following conditions (1 or 2) detected:
  1. Data from steering angle sensor cannot be received for 1 second or more.
  2. Data from steering angle sensor cannot be received once or more within 5 seconds.
CAN communication system

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO DTC CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)