VOLTAGE INVERTER > REMOVAL |
| 1. REMOVE REAR SEATBACK ASSEMBLY |
| 2. REMOVE REAR FLOOR BOARD |
![]() |
Remove the bolt and the luggage hold belt striker.
| *a | for RH Side |
| *b | for LH Side |
![]() |
Disengage the clip and the claw and remove the rear floor board.
| 3. REMOVE REAR FLOOR MAT SUPPORT PLATE |
![]() |
Remove the 5 screws.
![]() |
Disengage the 11 claws and remove the rear floor mat support plate.
| 4. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY |
![]() |
| *a | for RH Side |
| *b | for LH Side |
Remove the cap.
Remove the bolt and the luggage hold belt striker.
| 5. REMOVE REAR FLOOR MAT ASSEMBLY |
![]() |
Using a clip remover, remove the 2 clips and the rear floor mat.
| 6. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Disengage the 14 claws and remove the front door scuff plate.
| 7. REMOVE REAR DOOR SCUFF PLATE RH |
![]() |
Disengage the 6 claws and remove the access door scuff plate.
| 8. REMOVE PACKAGE HOLDER NET HOOK (w/o Amplifier Box Speaker Assembly) |
![]() |
| *a | for RH Side without Woofer |
| *b | for LH Side |
Remove the screw and the package holder net hook.
| 9. REMOVE QUARTER TRIM POCKET TRAY (w/o Amplifier Box Speaker Assembly) |
![]() |
Disengage the 7 claws and remove the quarter trim pocket tray.
| 10. REMOVE SIDE TRIM COVER (w/o Amplifier Box Speaker Assembly) |
![]() |
Disengage the 6 claws and the 2 guides remove the side trim cover.
| 11. REMOVE QUARTER TRIM POCKET (w/o Amplifier Box Speaker Assembly) |
![]() |
Disengage the 6 claws and remove the quarter trim pocket.
| 12. REMOVE DECK SIDE GARNISH (w/ Amplifier Box Speaker Assembly) |
![]() |
Disengage the 6 claws and remove the rear deck side garnish.
| 13. REMOVE SPEAKER MOUNTING COVER (w/ Amplifier Box Speaker Assembly) |
![]() |
Disengage the 8 clips and 2 guides and remove the speaker mounting cover.
| 14. REMOVE AMPLIFIER BOX SPEAKER ASSEMBLY (w/ Amplifier Box Speaker Assembly) |
![]() |
Disconnect the connectors.
Remove the 4 bolts and the amplifier box speaker.
| 15. REMOVE LAP BELT OUTER ANCHOR COVER |
![]() |
| *a | for RH Side |
| *b | for LH Side |
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 16. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH |
![]() |
Remove the bolt and the anchor plate.
| 17. REMOVE REAR DECK TRIM COVER |
![]() |
Disengage the 8 claws and remove the rear deck trim cover.
![]() |
Disconnect the power outlet connector.
| 18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
![]() |
Remove the 3 screws and bolt.
![]() |
Disengage the 6 clips and the 8 claws and remove the deck trim side panel.
| 19. REMOVE VOLTAGE INVERTER ASSEMBLY |
![]() |
Disconnect the 2 connectors and disengage the clamp.
Remove the bolt and ground wire.
![]() |
Remove the 3 bolts.
Disengage the guide and remove the voltage inverter assembly.