REAR AXLE HUB BOLT > INSTALLATION |
| 1. INSTALL REAR AXLE HUB BOLT |
![]() |
Install the washer and the nut onto a new hub bolt, as shown in the illustration.
Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.
| 2. APPLY HIGH TEMPERATURE GREASE |
Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.
| 3. INSTALL PARKING BRAKE SHOE |
![]() |
Apply high temperature grease to the adjusting bolt and piece.
Using needle-nose pliers, connect the parking brake cable to the parking brake shoe lever.
![]() |
Install the No. 1 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.
Install the return tension spring and shoe adjusting screw set.
Install the No. 2 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.
| 4. INSTALL PARKING BRAKE SHOE STRUT |
Attach the compression spring and parking brake shoe strut to the No. 2 and No. 1 shoes.
| 5. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING |
![]() |
Using needle-nose pliers, install the 2 return tension springs.
| 6. CHECK PARKING BRAKE INSTALLATION |
Check that each part is installed properly.

| 7. INSTALL REAR DISC |
Align the matchmarks of the disc and axle hub and install the disc.
| 8. ADJUST PARKING BRAKE SHOE CLEARANCE |
![]() |
Provisionally install the 2 hub nuts.
Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.
Contract the shoe adjuster until the disc rotates smoothly.
Install the hole plug.
| 9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the disc brake caliper with the 2 bolts and 2 washers.
| 10. INSTALL REAR WHEEL |
| 11. INSPECT PARKING BRAKE LEVER TRAVEL |
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
| 12. ADJUST PARKING BRAKE LEVER TRAVEL |
![]() |
Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
When operating the parking brake lever, check that the brake warning light illuminates.