Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


C133098
  1. Remove the 2 bolts and 2 washers and separate the disc brake caliper assembly.

    NOTICE:
    Suspend the disc brake caliper assembly with a piece of rope.



3. REMOVE REAR DISC
  1. Release the parking brake lever.



    D028126E05
  1. Place matchmarks on the disc and axle hub and remove the disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.



4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.



5. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.



6. REMOVE PARKING BRAKE SHOE


D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.



7. REMOVE REAR AXLE HUB BOLT


G020975E01
  1. Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.

    SST
    09650-17011