Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > INSPECTION

for Preparation Click here



1. INSPECT REAR AXLE SHAFT


R012254
  1. Using a dial indicator, measure the rear axle shaft runout and flange runout.

    Maximum runout:
    Shaft runout:
    1.5 mm (0.0591 in.)
    Flange runout:
    0.05 mm (0.0020 in.)

    If the rear axle shaft or flange is damaged or worn, or of runout of greater than the maximum, replace the rear axle shaft.