Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AXLE SHAFT SNAP RING


F042773
  1. Using a snap expander, remove the snap ring.



2. REMOVE REAR AXLE SHAFT


F042774E01
  1. Using SST and press, remove the rear axle shaft.

    SST
    09521-25011  
    09521-25021  

  1. Remove the rear axle bearing inner retainer from the axle hub.

  1. Remove the rear axle shaft washer from the axle hub.



    F042797
  1. Grind the rear axle bearing inner race surface using a grinder, then remove it with a chisel.

  1. Remove the rear axle shaft oil seal from the rear axle shaft.



3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


F042776
  1. Attach the 4 nuts to the housing bolts.

  1. Using a hammer, remove the 4 housing bolts and rear axle hub and bearing assembly.

    NOTICE:
    Do not reuse the nuts previously removed from the vehicle.



4. REMOVE BRAKE DRUM OIL DEFLECTOR


F042775E01
  1. Remove the deflector and deflector gasket to the rear axle shaft.

  1. Using SST, remove the 6 hub bolts.

    SST
    09650-17011