Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE DRUM OIL DEFLECTOR


    G020977E03
  1. Install a new deflector gasket and deflector onto the rear axle shaft.
    Text in Illustration 
    *a
    Notch

    HINT:
    Align the 2 notches.



    G020973
  1. Install the washer and nut onto a new hub bolt, as shown in the illustration.

  1. Install the hub bolt by tightening the nut.



2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


C236008
  1. Position the parking brake plate on a new rear axle hub and bearing assembly and install the 4 housing bolts using a 17 mm socket wrench and a press.

    HINT:
    The left and right side bearing assemblies have different part numbers and are not interchangeable side to side.



3. INSTALL REAR AXLE SHAFT


    G022121E04
  1. Install the washer and a new retainer onto the axle hub in the orientations shown in the illustration.
    Text in Illustration 
    *a
    Tapered Surface
    *b
    Chamfered Surface

    NOTICE:
    1. Install the washer with its tapered surface facing downward.
    2. Install the retainer with its chamfered surface facing downward.

  1. Using SST and a press, install the rear axle shaft onto the rear axle hub and bearing.

    SST
    09631-12090  
    09726-40010  
    09951-01100  



4. INSTALL REAR AXLE SHAFT SNAP RING


F042773
  1. Using a snap ring expander, install a new snap ring.