Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


E129562
  1. Disengage the 14 claws and remove the front door scuff plate.



2. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



3. REMOVE FOOTREST CLIP


    B130587
  1. Remove the 2 footrest clips.



4. REMOVE COWL SIDE TRIM BOARD LH


E129563
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board.



5. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



6. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Disengage the 3 claws and separate the hood lock control lever.



7. REMOVE INSTRUMENT PANEL FINISH PLATE


E149562E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.



8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



9. REMOVE TIRE PRESSURE WARNING RESET SWITCH


    C248792
  1. Disengage the 2 claws and remove the tire pressure warning reset switch from the lower instrument panel finish panel sub-assembly LH.