Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER NOZZLE

WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT WASHER NOZZLE
  1. Start the engine.



  1. Check where the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E127829E01

    Specification:
    Area
    Measurement
    A
    45.5 mm (1.79 in.)
    B
    39 mm (1.54 in.)
    C
    32.5 mm (1.28 in.)
    D
    206 mm (8.11 in.)
    E
    191.5 mm (7.54 in.)
    F
    177 mm (6.97 in.)
    G
    335 mm (13.19 in.)
    H
    328 mm (12.91 in.)
    I
    320 mm (12.60 in.)
    J
    158 mm (6.22 in.)
    K
    170.5 mm (6.71 in.)
    L
    183.5 mm (7.22 in.)

    HINT:
    If the result is not as specified, replace the washer nozzle.



2. INSPECT REAR WASHER NOZZLE (w/ Rear Wiper)
  1. Start the engine.



  1. Check where the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E127830E01

    Specification:
    Area
    Measurement
    A
    26.5 mm (1.04 in.)
    B
    77 mm (3.03 in.)
    C
    129.5 mm (5.10 in.)
    D
    200 mm (7.87 in.)
    E
    113.5 mm (4.47 in.)
    F
    66 mm (2.60 in.)
    G
    98 mm (3.86 in.)
    H
    202.5 mm (7.97 in.)
    I
    231.5 mm (9.11 in.)
    J
    54.5 mm (2.15 in.)
    K
    74.5 mm (2.93 in.)
    L
    120.5 mm (4.74 in.)

    HINT:
    If the result is not as specified, adjust the washer nozzle.



3. ADJUST REAR WASHER NOZZLE (w/ Rear Wiper)


    E129643
  1. Using a screwdriver, adjust the direction of the rear washer nozzle.

    HINT:
    Use a thin-bladed screwdriver with an approximately 1 mm thick tip.