Home › BODY ELECTRICAL › OTHER SYSTEM › VOLTAGE INVERTER

VOLTAGE INVERTER > INSPECTION

for Preparation Click here



1. INSPECT VOLTAGE INVERTER ASSEMBLY
  1. Connect the voltage inverter assembly to the vehicle wire harness.



    E260642E02
  1. Measure the voltage and resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component with harness connected
    (Voltage Inverter Assembly)

    Standard:

    Tester Connection
    Switch Condition
    Specified Condition
    K2-2 (+B) - K2-1 (GND)
    Ignition Switch ON
    11 to 14 V
    K6-1 (SW) - Body Ground
    Always
    Below 1 Ω
    K6-5 (AC1) - K6-11(AC2)
    Ignition Switch ON,
    Inverter Main Switch ON
    AC 108 to 132 V

    If the result is not as specified, replace the voltage inverter assembly