Home › BODY › WINDSHIELD / WINDOWGLASS › BACK DOOR GLASS

BACK DOOR GLASS > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE SPARE DISC WHEEL


3. REMOVE NO. 1 REAR SPOILER COVER


E127215
  1. Remove the 4 screws and No. 1 rear spoiler cover.



4. REMOVE REAR SPOILER


    B135162
  1. Disconnect high mounted stop light connector.

  1. Using a clip remover, remove the 3 clamps.

  1. Remove the washer hose from the claw of the rear spoiler.

  1. Disconnect the washer hose.



    B135163
  1. Remove the 4 nuts.



5. REMOVE BACK WINDOW SUPPORT LH


B135523
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and back window support.

    NOTICE:
    1. Do not touch the rod of the back window support with gloves, to avoid fibers from adhering.
    2. When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.

    HINT:
    Support the back door glass by hand while removing the back window support.



6. REMOVE BACK WINDOW SUPPORT RH

HINT:
Use the same procedure as for the LH side.



7. REMOVE BACK DOOR GLASS
  1. Disconnect the 2 defogger connectors.



    B139403
  1. Remove the 2 nuts and the back door glass.



8. REMOVE BACK WINDOW STAY UPPER BRACKET RH


B139404
  1. Remove the 2 screws, the retainer and the back window stay upper bracket.



9. REMOVE BACK WINDOW STAY UPPER BRACKET LH

HINT:
Use the same procedure as described for the RH side.



10. REMOVE BACK WINDOW LOCK STRIKER ASSEMBLY


B139405
  1. Remove the 2 screws, the retainer and the back window lock striker.



11. REMOVE BACK DOOR OUTSIDE HANDLE


B139406
  1. Remove the screw and the back door outside handle.

  1. Remove the bush.