Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


    A078431E43
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected:
    (Crankshaft Position Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    1630 to 2740 Ω
    Hot
    2065 to 3225 Ω

    NOTICE:
    In the table above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the sensor.