Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
  1. Avoid physical shocks to the accelerator pedal rod assembly.
  2. Do not disassemble the accelerator pedal rod assembly.

  1. Install the accelerator pedal rod assembly with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    Do not apply oil or lubricant to the accelerator pedal rod assembly. If it is applied, the accelerator pedal rod assembly may not move smoothly.

  1. Connect the accelerator pedal rod assembly connector.