Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR

ULTRASONIC SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER


    E185141E01
  1. Temporarily install the ultrasonic sensor retainer to the rear bumper.
    Text in Illustration 
    *1
    Protrusion
    *2
    Keyhole

    NOTICE:
    1. Do not damage the rear bumper with the protrusion when installing the retainer.
    2. Securely install the ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

    HINT:
    When installing the retainer, align the keyhole and protrusion as shown in the illustration.

  1. Engage the 2 claws to install the ultrasonic sensor retainer.



2. INSTALL NO. 1 ULTRASONIC SENSOR
  1. Engage the 2 claws to install the ultrasonic sensor.

    NOTICE:
    Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

  1. Connect the connector.



3. INSTALL REAR BUMPER COVER
(Click here)