Home › ENGINE › 1GR-FE STARTING › STARTER RELAY

STARTER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE STARTER RELAY


A126393E05
  1. Remove the relay block cover upper.

  1. Remove the starter relay.
    Text in Illustration 
    *1
    Relay Block Cover
    *2
    Starter Relay



3. INSPECT STARTER RELAY


A126370
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the relay.



4. INSTALL STARTER RELAY
  1. Install the starter relay.

  1. Install the relay block cover upper.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }