Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY


  1. Check the resistance.


    E219811E02


    Text in Illustration 
    *a
    Volume+
    *b
    Volume-
    *c
    Seek-
    *d
    MODE
    *e
    Seek+
    *f
    Off Hook
    *g
    On Hook
    *h
    Voice
    *i
    Component without harness connected
    (Steering Pad Switch Assembly)
    -
    -

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      12 (AU1) - 10 (EAU)
      No switch is pushed
      95 to 105 kΩ
      Seek+ switch pushed
      Below 2.5 Ω
      Seek- switch pushed
      312 to 345 Ω
      Volume+ switch pushed
      950 to 1050 Ω
      Volume- switch pushed
      2954 to 3265 Ω
      11 (AU2) - 10 (EAU)
      No switch is pushed
      95 to 105 kΩ
      MODE switch pushed
      Below 2.5 Ω
      On hook switch pushed
      312 to 345 Ω
      Off hook switch pushed
      950 to 1050 Ω
      Voice switch pushed
      2954 to 3265 Ω

      If the result is not as specified, replace the steering pad switch.



  1. Check the operation.


    E219841E02


    Text in Illustration 
    *a
    Component without harness connected
    (Steering Pad Switch Assembly)
    -
    -

    1. Apply battery voltage to the terminals and check that the indicator illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) - Terminal 1 (ILL+)
      Battery negative (-) - Terminal 10 (EAU)
      Illuminates

      If the result is not as specified, replace the steering switch.