STEERING PAD SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING WHEEL LOWER COVER LH |
![]() |
Using a thin-bladed screwdriver, remove steering wheel cover lower No.3.
| 3. REMOVE STEERING WHEEL LOWER COVER RH |
![]() |
Using a thin-bladed screwdriver, remove steering wheel cover lower No.2.
| 4. REMOVE STEERING PAD |
![]() |
Using "Torx" socket wrench (T30), loosen the 2 "Torx" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
Remove the steering pad.
| 5. REMOVE STEERING PAD SWITCH ASSEMBLY |
![]() |
w/ Cruise Control System:
| *1 | Pin |
| *b | Guide |
Disconnect the cruise control switch connector.
Disconnect the connector and 3 guides.
Remove the 2 screws.
Disengage the 4 claws and the 2 pins and remove the steering pad switch.