Camshaft timing oil control valve assembly
| Resistance:
| 1 - 2
| 6.9 to 7.9 Ω at 20 °C (68°F)
|
Throttle with motor body assembly
| Resistance
| 1(M-) - 2(M+)
| 0.3 to 100 Ω at 20 °C (68°F)
|
Accelerator pedal position No. 1 standard voltage
| Voltage
| Accelerator pedal released
| 0.5 to 1.1 V
|
Accelerator pedal depressed
| 2.6 to 4.5 V
|
Accelerator pedal position No. 2 standard voltage
| Voltage
| Accelerator pedal released
| 1.2 to 2.0 V
|
Accelerator pedal depressed
| 3.4 to 5.0 V
|
Mass air flow meter
| Resistance
| 1(THA) - 2(E2)
| 13.6 to 18.4 KΩ at -20 °C (4°F)
|
2.21 to 2.69 KΩ at 20 °C (68°F)
|
0.49 to 0.67 KΩ at 60 °C (140°F)
|
Crankshaft position sensor
| Resistance
| 1 - 2
| 1850 to 2450 Ω at 20°C (68°F)
|
Engine coolant temperature sensor
| Resistance:
| 1 - 2
| 2.32 to 2.59 Ω at 20 °C (68°F)
|
1 - 2
| 0.310 to 0.326 Ω at 80°C (176°F)
|
Knock sensor
| Resistance
| 1 - 2
| 120 to 280 Ω at 20 °C (68°F)
|
Air fuel ratio sensor (for Bank1)
| Resistance
| 2(+B) - 1(HA1A)
| 1.8 to 3.4 Ω at 20°C (68°F)
|
1(HA1A) - 4(A1A-)
| 10 kΩ or higher
|
Air fuel ratio sensor (for Bank2)
| Resistance
| 2(+B) - 1(HA2A)
| 1.8 to 3.4 Ω at 20°C (68°F)
|
1(HA2A) - 4(A2A-)
| 10 kΩ or higher
|
Heated oxygen sensor (for Bank1)
| Resistance
| 1(HT1B) - 2 (+B)
| 11 to 16 Ω at 20°C (68°F)
|
1(HT1B) - 4 (E2)
| 10 kΩ or higher
|
Heated oxygen sensor (for Bank2)
| Resistance
| 1(HT2B) - 2 (+B)
| 11 to 16 Ω at 20°C (68°F)
|
1(HT2B) - 4 (E2)
| 10 kΩ or higher
|
EFI relay
| Resistance
| 3 - 5
| 10 kΩ or higher (Battery voltage not applied)
|
Below 1 Ω (Battery voltage applied to terminals 1 and 2)
|
Circuit opening relay
| Resistance
| 3 - 5
| 10 kΩ or higher (Battery voltage not applied)
|
1 - 2
| Below 1 Ω (Battery voltage applied to terminals 1 and 2)
|
A/F sensor heater relay
| Resistance
| 3 - 4
| Below 1 Ω (Battery voltage not applied)
|
10 kΩ or higher (Battery voltage applied to terminals 1 and 2)
|
3 - 5
| 10 kΩ or higher (Battery voltage not applied)
|
Below 1 Ω (Battery voltage applied to terminals 1 and 2)
|