Home › SUSPENSION & AXLE › SUSPENSION › FRONT PERFORMANCE DAMPER

FRONT PERFORMANCE DAMPER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SUSPENSION MEMBER DAMPER ASSEMBLY


    C290904E01
  1. Using a drill or similar tool, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

    A to B:
    30 mm (1.18 in.)

    CAUTION:
    Always use proper safety equipment and be careful when drilling because shards of metal may fly about.

    NOTICE:
    1. Since the discharging gas may cause chips to scatter, cover the drill or similar tool with a piece of cloth when making the hole.
    2. The gas is colorless, odorless and non-poisonous.