AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR > INSPECTION |
| 1. INSPECT AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR |
Check Free to Lock switch.

Connect lines via a relay as shown in the illustration, then check that the actuator fork moves from the Free to Lock position.
After the Free to Lock switch is complete, inspect the A.D.D. detection switch and limit switch
| Tester Connection | Condition | Specified Condition |
| 3 (ADD) - 4 (GND) | After Free to Lock switch is complete | Below 12.5 Ω |
| 5 (DL2) - 4 (GND) | Below 12.5 Ω | |
| 6 (DL1) - 4 (GND) | 0.5 MΩ or higher |
Check Lock to Free switch.

Connect lines via a relay as shown in the illustration, then check that the actuator fork moves from the Lock to Free position.
After the Lock to Free switch is complete, inspect the A.D.D. detection switch and limit switch.
| Tester Connection | Condition | Specified Condition |
| 3 (ADD) - 4 (GND) | After Lock to Free switch is complete | 0.5 MΩ or higher |
| 5 (DL2) - 4 (GND) | 0.5 MΩ or higher | |
| 6 (DL1) - 4 (GND) | Below 12.5 Ω |