Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C248793E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)
    *b
    ON (Pushed in)
    *c
    OFF (Released)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the tire pressure warning reset switch.