Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the sensor.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector.



    A229665E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



2. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
  1. Disconnect the sensor connector.



    A223689E02
  1. Using SST, remove the sensor.

    SST
    09224-00010