Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 1GR-FE STARTING

1GR-FE STARTING > SERVICE DATA



Starter assembly
Standard current
90 A or less at 11.5 V
Magnet starter switch assembly resistance
Terminal 50 - Terminal C
Below 1 Ω
Terminal 50 - Switch body
Below 2 Ω
Starter brush holder assembly Brush length
Standard length
15.5 mm (0.610 in.)
Minimum length
8.5 mm (0.335 in.)
Starter yoke assembly Brush length
Standard length
15.5 mm (0.610 in.)
Minimum length
8.5 mm (0.335 in.)
Starter brush holder assembly Brush spring load
Standard spring load
18 to 24 N (1.8 to 2.4 kgf, 4.0 to 5.3 lbf)
Minimum spring load
12 N (1 kgf, 2.7 lbf)
Starter brush holder assembly resistance
Standard resistance
Positive (+) brush holder - Negative (-) brush holder
10 kΩ or higher
Starter yoke assembly resistance
Lead wire - Brush
Below 1 Ω
Starter yoke Body - Brush
10 kΩ or higher
Starter armature assembly resistance
Segment - Segment
Below 1 Ω
Segment - Coil core
10 kΩ or higher
Starter armature assembly commutator circle runout
Minimum runout
0.05 mm (0.00197 in.)
Starter armature assembly commutator diameter
Standard diameter
30.0 mm (1.18 in.)
Minimum diameter
29.0 mm (1.14 in.)
Starter armature assembly undercut depth
Standard depth
0.6 mm (0.0236 in.)
Minimum depth
0.2 mm (0.0787 in.)
Starter relay
Standard resistance
3 - 5
10 kΩ or higher (Battery voltage not applied)
Below 1 Ω (Battery voltage applied to terminals 1 and 2)
Ignition switch
Standard resistance
Between all terminals
10 kΩ or higher
(LOCK)
Standard resistance
1 (AM1) - 3 (ACC)
Below 1 Ω
(ACC)
Standard resistance
1 (AM1) - 3 (ACC) - 4 (IG1)
Below 1 Ω
(ON)
Standard resistance
7 (IG2) - 8 (AM2)
Standard resistance
1 (AM1) - 2 (ST1) - 4 (IG1)
Below 1 Ω
(START)
Standard resistance
6 (ST2) - 7 (IG2) - 8 (AM2)