Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Power Steering Signal.

    5. Start the engine.

    6. Operate the steering wheel while idling, and read the value on the Techstream.

      OK:
      Condition
      Specified Condition
      Power steering operation
      ON
      Power steering not operation
      OFF

      If the result is not as specified, replace the oil pressure switch.