Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here


  1. Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM (Click here or Click here).
  2. Perform the REGISTRATION (VIN registration) when replacing the ECM (Click here).
  3. If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning lamp (Click here or Click here).


1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B133854E01
  1. Disengage the claw and separate the glove compartment door stoppers from the glove compartment door.

  1. Slightly flex the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door until it becomes horizontal.



    B133855
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.



2. REMOVE 4 WHEEL DRIVE CONTROL ECU NO.2 (for Automatic Transmission 4WD)


A226612
  1. Disconnect the connector.

  1. Remove the bolt and four wheel drive control ECU.



3. REMOVE ECM


    A226613
  1. Disconnect the 6 connectors.

  1. Remove the 3 nuts and ECM.



4. REMOVE ECM BRACKET


A226614
  1. Remove the 2 screws and ECM bracket.



5. REMOVE NO. 2 ECM BRACKET


A226615
  1. Remove the 2 screws and No. 2 ECM bracket.