Home › ENGINE › 1GR-FE INTAKE › AIR CLEANER AND HOSE

AIR CLEANER AND HOSE > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 AIR CLEANER HOSE
  1. Install the union (fog air cleaner hose) tube to the No. 1 air cleaner hose.



2. INSTALL INTAKE AIR RESONATOR


    A226868E01
  1. Align the tab on the No. 1 air cleaner hose with the groove on the intake air resonator and tighten the 2 hose clamps.
    Text in Illustration 
    *a
    Protrusion
    *b
    RH
    *c
    Top

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    The direction of the hose clamp is indicated in the illustration.



3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    A227192E01
  1. Align the tab on the air cleaner cap with the groove on the air cleaner hose and tighten the hose clamp.
    Text in Illustration 
    *a
    Protrusion
    *b
    Groove
    *c
    Top
    *d
    Front

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    HINT:
    The direction of the hose clamp is indicated in the illustration.



4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
  1. Install the air cleaner case sub-assembly with the 3 bolts.



5. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
  1. Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.



6. INSTALL AIR CLEANER CAP AND HOSE


    A227195E01
  1. Install the air cleaner cap with the 4 hinges.

  1. Install the No. 1 air cleaner hose with the clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    Text in Illustration 
    *a
    Protrusion
    *b
    Groove
    *c
    Top
    *d
    Front
    *e
    RH
    *f
    Paint mark of the hose

  1. Install the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the ventilation hose and vacuum hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Engage the 4 wire harness clamps.

  1. Connect the MAF meter connector.



7. INSTALL V-BANK COVER
  1. Engage the 2 hooks and install the V-bank cover to the No. 1 V-bank cover bracket.

  1. Align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to engage the pins.



8. INSPECT INTAKE SYSTEM