IGNITION KEY CYLINDER LIGHT > INSTALLATION |
| 1. INSTALL TRANSPONDER KEY AMPLIFIER |
![]() |
Engage the 2 claws and install the transponder key amplifier.
Connect the connector.
| 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Engage the claw and 5 clips and install the lower instrument panel finish panel.
Connect the connector.
Tighten the 2 bolts.
| 3. INSTALL INSTRUMENT PANEL FINISH PLATE |
![]() |
Install the instrument panel finish plate.
| 4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Engage the 3 claws and install the hood lock control lever.
| 5. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 4 clips and 2 claws and install the instrument panel register.
| 6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 7. INSTALL COWL SIDE TRIM BOARD LH |
| 8. INSTALL FOOTREST CLIP |
![]() |
Engage the 2 claws and install the footrest clip.
| 9. INSTALL FRONT FLOOR FOOTREST |
![]() |
Engage the 2 studs and install the front floor footrest.
| 10. INSTALL FRONT DOOR SCUFF PLATE LH |