Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


E149559E01
  1. Check the illumination operation of the ignition key cylinder light.

    1. Apply battery voltage to the transponder key amplifier and check that the illumination comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2 (Ill+)
      Battery negative (-) → Terminal 6 (Ill-)
      Illumination comes on

      If the result is not as specified, replace the transponder key amplifier.