Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



2. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



3. REMOVE FOOTREST CLIP


    B130587
  1. Remove the 2 footrest clips.



4. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side .



6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



7. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Disengage the 3 claws and separate the hood lock control lever.



8. REMOVE INSTRUMENT PANEL FINISH PLATE


E149562E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


E146361
  1. Remove the 2 bolts.

  1. Disengage the claw and 5 clips and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



10. REMOVE TRANSPONDER KEY AMPLIFIER


E146362E01
  1. Disconnect the connector.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the transponder key amplifier.