POWER STEERING LINK > DISASSEMBLY |
| 1. REMOVE TURN PRESSURE TUBE LH |
![]() |
Using a union nut wrench (12 mm), remove the turn pressure tube LH.
Remove the 2 O-rings from the turn pressure tube LH.
| 2. REMOVE TURN PRESSURE TUBE RH |
![]() |
Using a union nut wrench (12 mm), remove the turn pressure tube RH.
Remove the 2 O-rings from the turn pressure tube RH.
| 3. SECURE POWER STEERING LINK ASSEMBLY |
![]() |
Using SST wrapped in protective tape, secure the power steering link assembly in a vise.
| *1 | Protective Tape |
| 4. REMOVE STEERING GEAR OUTLET RETURN TUBE |
![]() |
Using a union nut wrench (17 mm), remove the steering gear outlet return tube from the power steering link assembly.
| 5. REMOVE TIE ROD END SUB-ASSEMBLY LH |
![]() |
Put matchmarks on the tie rod end sub-assembly LH and the steering rack end sub-assembly.
| *a | Matchmark |
| *b | Length A |
Measure length A and record the measurement.
Remove the tie rod end sub-assembly LH.
| 6. REMOVE TIE ROD END SUB-ASSEMBLY RH |
| 7. REMOVE STEERING RACK BOOT CLIP (for LH Side) |
Using pliers, remove the steering rack boot clip.
| 8. REMOVE STEERING RACK BOOT CLIP (for RH Side) |
| 9. REMOVE STEERING RACK BOOT CLAMP (for LH Side) |
![]() |
Using pliers, remove the steering rack boot clamp as shown in the illustration.
| 10. REMOVE STEERING RACK BOOT CLAMP (for RH Side) |
| 11. REMOVE NO. 2 STEERING RACK BOOT |
Remove the No. 2 steering rack boot.
| 12. REMOVE NO. 1 STEERING RACK BOOT |
| 13. REMOVE STEERING RACK END SUB-ASSEMBLY (for LH Side) |
![]() |
Using SST, remove the steering rack end sub-assembly while holding the steering rack.
| *a | Hold |
| *b | Turn |
| 14. REMOVE STEERING RACK END SUB-ASSEMBLY (for RH Side) |
![]() |
Using SST, remove the steering rack end sub-assembly while holding the steering rack.
| *a | Hold |
| *b | Turn |