POWER STEERING LINK > REASSEMBLY |
| 1. INSTALL STEERING RACK END SUB-ASSEMBLY (for LH Side) |
Temporarily install the steering rack end sub-assembly to the steering rack.
Fill up the ball joint of the steering rack end sub-assembly with MP grease.
![]() |
Using SST, install the steering rack end sub-assembly while holding the steering rack.
| *a | Hold |
| *b | Turn |
| 2. INSTALL STEERING RACK END SUB-ASSEMBLY (for RH Side) |
Temporarily install the steering rack end sub-assembly to the steering rack.
Fill up the ball joint of the steering rack end sub-assembly with MP grease.
![]() |
Using SST, install the steering rack end sub-assembly while holding the steering rack.
| *a | Hold |
| *b | Turn |
| 3. INSTALL NO. 2 STEERING RACK BOOT |
![]() |
Apply lithium soap base glycol grease to the inside of the small opening of the No. 2 steering rack boot.
![]() | Lithium soap base glycol grease |
Install the No. 2 steering rack boot to the groove on the rack housing.
| 4. INSTALL NO. 1 STEERING RACK BOOT |
| 5. INSTALL STEERING RACK BOOT CLAMP (for LH Side) |
![]() |
Using SST, tighten a new steering rack boot clamp (LH side) as shown in the illustration.
| 6. INSTALL STEERING RACK BOOT CLAMP (for RH Side) |
| 7. INSTALL STEERING RACK BOOT CLIP (for LH Side) |
Using pliers, install the steering rack boot clip.
| 8. INSTALL STEERING RACK BOOT CLIP (for RH Side) |
| 9. INSTALL TIE ROD END SUB-ASSEMBLY LH |
![]() |
Temporarily install the lock nut and the tie rod end sub-assembly LH to the steering rack end sub-assembly until the matchmarks and length A are aligned, then temporarily tighten the lock nut.
| *a | Matchmark |
| *b | Length A |
| 10. INSTALL TIE ROD END SUB-ASSEMBLY RH |
| 11. INSTALL STEERING GEAR OUTLET RETURN TUBE |
![]() |
Using a union nut wrench (17 mm), install the steering gear outlet return tube to the power steering link assembly.
| 12. INSTALL TURN PRESSURE TUBE RH |
Apply power steering fluid to 2 new O-rings.
Install the 2 O-rings to the turn pressure tube RH.
![]() |
Using a union nut wrench (12 mm), install the turn pressure tube RH.
| 13. INSTALL TURN PRESSURE TUBE LH |
Apply power steering fluid to 2 new O-rings.
Install the 2 O-rings to the turn pressure tube LH.
![]() |
Using a union nut wrench (12 mm), install the turn pressure tube LH.