Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CURTAIN AIRBAG CUTOFF SWITCH


    B207805E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SW) - 4 (E)
    Switch is not pressed
    10 kΩ or higher
    3 (SW) - 4 (E)
    Switch is pressed
    Below 1 Ω

    If the result is not as specified, replace the switch.

  1. Check the illumination operation.

    1. Connect the positive (+) lead from the battery to terminal 2 (ILL+) and the negative (-) lead to terminal 1 (ILL-), and then check that the illumination lights up.

      OK:
      Bulb illuminates

      If the result is not as specified, replace the switch.