Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING OIL PRESSURE SWITCH
  1. Install a new O-ring to the power steering oil pressure switch.



    A226978E01
  1. Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.
    Text in Illustration 
    *a
    New O-Ring

  1. Using a 24 mm deep socket wrench, install the power steering oil pressure switch.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

    NOTICE:
    1. Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (connecting surface with pressure feed tube).
    2. Be careful not to damage the O-ring when installing the power steering oil pressure switch

  1. Connect the power steering oil pressure switch connector.



2. ADD POWER STEERING FLUID


3. INSPECT FOR POWER STEERING FLUID LEAK


4. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

    1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel to the left or right full lock position and keep it there for 2 to 3 seconds. Then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds (step A).

    2. Repeat step A several times.

  1. Stop the engine.



    C133819E02
  1. Check for foaming or emulsification.
    Text in Illustration 
    *a
    Normal
    *b
    Abnormal
    Especially, if the system has to be bled twice because of foaming or emulsification, check for fluid leakage in the system.

  1. Check the fluid level.