CRAWL SWITCH > INSPECTION |
| 1. INSPECT CRAWL CONTROL SWITCH ASSEMBLY |
![]() |
| *1 | CRAWL ON/OFF Switch |
| *2 | CRAWL Speed Selector Switch |
| *a | Component without harness connected (Crawl Control Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (SWI1) - 6 (SWO2) | Speed selector switch: Low | 1379 to 2561 Ω |
| Speed selector switch: Medium-low | 1071 to 1989 Ω | |
| Speed selector switch: Medium | 700 to 1300 Ω | |
| Speed selector switch: Medium-high | 329 to 611 Ω | |
| Speed selector switch: High | 21 to 39 Ω | |
| 6 (SWO2) - 8 (SWO4) | Speed selector switch: Low | 21 to 39 Ω |
| Speed selector switch: Medium-low | 329 to 611 Ω | |
| Speed selector switch: Medium | 700 to 1300 Ω | |
| Speed selector switch: Medium-high | 1071 to 1989 Ω | |
| Speed selector switch: High | 1379 to 2561 Ω | |
| 2 (SWI3) - 8 (SWO4) | ON/OFF switch: Pressed | Below 1 Ω |
| ON/OFF switch: Not pressed | 10 kΩ or higher |