Home › BRAKE › BRAKE CONTROL › CRAWL SWITCH

CRAWL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRAWL CONTROL SWITCH ASSEMBLY
  1. Install the crawl control switch assembly to the personal light assembly with the 4 screws.

  1. Engage the 4 claws and the 2 guides and install the bulb housing sub-assembly to the personal light assembly.

  1. Install the 6 screws to the personal light assembly.

  1. Connect the 3 connectors to the personal light assembly.



2. INSTALL PERSONAL LIGHT ASSEMBLY
(Click here)