Home › ENGINE › 1GR-FE FUEL › FUEL PUMP ECU

FUEL PUMP ECU > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY (w/ Secondary Air Injection System)
  1. Install the No. 1 fuel pump control ECU bracket and No. 2 fuel pump control ECU bracket to the fuel pump control ECU assembly with the 4 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Engage the hook and install the fuel pump control ECU assembly to the frame sub-assembly with the 2 bolts.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }

    NOTICE:
    Do not use the fuel pump control ECU assembly if it has been subjected to physical shocks such as being dropped, etc.



    A282110
  1. Connect the fuel pump control ECU assembly connector.

  1. Rotate the lever in the direction of the arrow until a "click" sound is hard.



2. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY (w/o Secondary Air Injection System)
  1. Engage the hook and install the fuel pump control ECU assembly to the frame sub-assembly with the 2 bolts.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }

    NOTICE:
    Do not use the fuel pump control ECU assembly if it has been subjected to physical shocks such as being dropped, etc.

  1. Connect the 2 fuel pump control ECU connectors.