Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1440    Steering Angle Sensor Unusual Bank Angle Detected

for Preparation Click here


DESCRIPTION

If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.

HINT:
DTC C1440 and the yaw rate and deceleration sensor DTC are stored when the skid control ECU determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:

  1. The yaw rate and deceleration sensor is installed at an angle.
  2. The yaw rate and deceleration sensor signal output is stuck.

DTC Code
DTC Detection Condition
Trouble Area
C1440
Driving at a steep bank angle.
Yaw rate and deceleration sensor

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC C1440 is output
    A
    DTC C1440 is not output
    B
    Yaw rate and deceleration sensor DTC is output
    C



B
END

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.CHECK DTC
  1. Clear the DTCs (Click here).

    HINT:
    1. If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
    2. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.


NEXT

END