A-TRAC SWITCH (w/o CRAWL) > INSPECTION |
| 1. INSPECT NO. 2 TRACTION CONTROL SWITCH (A-TRAC SWITCH) |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (No. 2 traction control switch (A-TRAC switch)) |
| Tester Connection | Switch Condition | Specified Condition |
| 3 - 4 | Pressed | Below 1 Ω |
| Not pressed | 10 kΩ or higher |