Home › BRAKE › BRAKE CONTROL › A-TRAC SWITCH (w/ CRAWL)

A-TRAC SWITCH (w/ CRAWL) > INSPECTION

for Preparation Click here



1. INSPECT TRANSFER POSITION SWITCH (A-TRAC SWITCH)


    C266308E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Transfer position switch (A-TRAC switch))

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (E) - 8 (ATRC)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    If the value is not as specified, replace the transfer position switch (A-TRAC switch).