Home › DRIVE LINE · DIFFERENTIAL › REAR DIFFERENTIAL LOCK CONTROL SWITCH (w/ CRAWL)

REAR DIFFERENTIAL LOCK CONTROL SWITCH (w/ CRAWL) > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL LOCK SWITCH


    C172874E07
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Differential lock switch)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E) - 4 (B)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    If the result is not as specified, replace the differential lock switch.