Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0129    Lost Communication with Brake System Control Module

DTC    U0151    Lost Communication with Airbag ECU

for Preparation Click here


DESCRIPTION

The combination meter communicates with the ECM, skid control ECU and center airbag sensor via the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
U0100
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with ECM continues for 2 seconds or more
  1. CAN communication system
  2. ECM
U0129
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with skid control ECU continues for 3 seconds or more
  1. CAN communication system
  2. Skid control ECU
U0151
When the following condition is detected:
  1. No communication with center airbag sensor assembly continues for 10 seconds or more
  1. CAN communication system
  2. Center airbag sensor assembly

INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

  1. Clear DTCs (Click here).

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is output.
    A
    DTC is not output.
    B

    HINT:
    If CAN communication system DTC U0100, U0129 or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129 or U0151 first.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)