Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Multi-media Interface ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the multi-media interface ECU.

WIRING DIAGRAM


E180194E73


INSPECTION PROCEDURE

1.INSPECT MULTI-MEDIA INTERFACE ECU
  1. Disconnect the E82 multi-media interface ECU connector.



    E182617E59
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E82-12 (+B) - E82-7 (GND)
    Always
    11 to 14 V
    E82-11 (ACC) - E82-7 (GND)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-media interface ECU)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the E84 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E82-11 (ACC) - E84-11 (ACC)
    Always
    Below 1 Ω
    E82-12 (+B) - E84-12 (+B)
    Always
    Below 1 Ω
    E82-7 (GND) - E84-7 (GND)
    Always
    Below 1 Ω
    E82-11 (ACC) - Body ground
    Always
    10 kΩ or higher
    E82-12 (B+) - Body ground
    Always
    10 kΩ or higher
    E82-7 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)