Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C120A    ECU Initial Setting Incomplete

for Preparation Click here


DESCRIPTION

The skid control ECU (master cylinder solenoid) uses terminal NEO to determine the drive configuration of the skid control ECU (master cylinder solenoid).

DTC Code
DTC Detection Condition
Trouble Area
C120A
Short detected in Terminal NEO at IG ON*1
Open detected in Terminal NEO at IG ON*2
  1. Master cylinder solenoid (Skid control ECU)
  2. Harness or connector
  1. *1: for 2WD
  2. *2: for 4WD

WIRING DIAGRAM


C231262E01


INSPECTION PROCEDURE

1.CHECK VEHICLE EQUIPMENT
  1. Confirm whether the vehicle is 2WD or 4WD.
    Result 
    Result
    Proceed to
    for 2WD
    A
    for 4WD
    B



B
Go to step 4
A


2.CHECK CONNECTOR CONNECTION CONDITION
  1. Disconnect the A4 skid control ECU connector.

  1. Confirm that the connector's contacts are not contaminated by foreign substances or water seepage.

    OK:
    Connector's contacts are not contaminated by foreign substances or water seepage.



NG
CLEAN CONNECTOR
OK


3.INSPECT SKID CONTROL ECU (NEO TERMINAL)
  1. Disconnect the A4 skid control ECU connector.



    C213546E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-43 (NEO) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)  

4.INSPECT SKID CONTROL ECU (NEO TERMINAL)
  1. Disconnect the A4 skid control ECU connector.



    C213546E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-43 (NEO) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is recorded (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)