CAN COMMUNICATION SYSTEM > Driving Support Switch Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Driving Support Switch Control ECU Communication Stop Mode |
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (DRIVING SUPPORT SWITCH CONTROL ECU) |
Turn the ignition switch off.
![]() |
Disconnect the driving support switch control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E89-8 (CANH) - E89-3 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Driving Support Switch Control ECU) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT SWITCH CONTROL ECU -) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E89-16 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E89-6 (+B) - Body ground | Always | 11 to 14 V |
| E89-2 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Driving Support Switch Control ECU) |
|
| ||||
| OK | ||
| ||