Home › ENGINE › 1GR-FE EMISSION CONTROL › AIR PUMP (w/ Secondary Air Injection System)

AIR PUMP (w/ Secondary Air Injection System) > INSTALLATION

for Preparation Click here



1. INSTALL INLET AIR PUMP
  1. Engage the 4 claws and install the inlet air pump to the air pump assembly.



2. INSTALL AIR PUMP INSULATOR
  1. Install the 3 air pump insulators to the No.1 air pump bracket.



3. INSTALL AIR PUMP ASSEMBLY


    A223879E03
  1. Engage the 3 fittings of the air pump insulator to install the air pump assembly to the No. 1 air pump bracket.
    Text in Illustration 
    *1
    Air Pump Insulator
    *2
    Air Pump Assembly
    *3
    No. 1 Air Pump Bracket

  1. Engage the 2 wire harness clamps and install the wire harness to the No. 1 air pump bracket.

  1. Install the air pump with No. 1 air pump bracket to the engine room compartment with the 3 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Engage the wire harness clamp and install the wire harness to the No. 1 air pump bracket.

  1. Connect the air pump assembly connector.



4. CONNECT NO. 1 AIR INJECTION SYSTEM HOSE


    A288089E01
  1. Connect the No. 1 air injection system hose to the air pump assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protrusion of Air Pump Assembly
    *2
    Paint Mark of No. 1 Air Injection System Hose
    *3
    No. 1 Air Injection System Hose
    *a
    View A
    *b
    Upper of Vehicle
    *c
    Front of Vehicle

    HINT:
    1. Make sure the paint mark of the No. 1 air injection system hose is facing upward.
    2. Make sure the direction of the hose clip is as shown in the illustration.



5. INSTALL AIR PUMP COVER
  1. Engage the 3 claws and install the air pump cover to the air pump assembly.

    HINT:
    Make sure the inlet air pump is oriented correctly and completely attached when installing the air pump cover.