Home › ENGINE › 1GR-FE EMISSION CONTROL › AIR INJECTION DRIVER

AIR INJECTION DRIVER > INSTALLATION

for Preparation Click here



1. INSTALL AIR INJECTION CONTROL DRIVER
  1. Install the air injection control driver to the injector driver bracket with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the air injection control driver with injector driver bracket to the engine room compartment with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the 2 air injection control driver connectors.